view file of plan always shows justifications

[sharla]

In a couple of the view files, our x'refed plan (from the construct) viewed with the cleanup radius's showing and the justification lines on. Is there a way to control this? It did not view this way in the sheet files.

[stelthorst]

It sounds like a Display Representation (DR) problem. Verify that the DR being used in the drawing with problems is identical to the DR a drawing that is working correctly.

Hope this helps.

[dkoch]

In a couple of the view files, our x'refed plan (from the construct) viewed with the cleanup radius's showing and the justification lines on. Is there a way to control this? It did not view this way in the sheet files.

The Graph Display Representation for Walls must be active in your view files. The first thing to check is whether there is a Display Configuration override set on the Xrefs. If not, then I believe that you would want to turn off the Graph Display Representation in the View file, but since I do not use Project Navigator very often and I am not testing this as I write this, I could be wrong about that. If turning it off in the View file does not work (or it was already off), then turn it off in the Construct file as well.

In the View file, with the Display Configuration and view direction set to those giving you the problem, open the Display Manager. Expand the Configurations folder in the left pane, find the Configuration shown in bold type (the current one) and expand that and, finally, select the Display Representation set in bold type (the currently active one, associated with the current view direction). In the right pane, on the Display Representation Control tab, scroll down to the Walls row and clear any check mark in the Graph column. OK your way back out.

In the Construct file (if necessary), you could do the same, or, with the Display Configuration and view direction to affect set current, you could select a Wall, right click, and choose Cleanups > Toggle Wall Graph Display, to turn the Graph Display Representation off (if it is on) or on (if it is off).

If a Display Configuration override is set on the Xrefs, then, assuming you want to keep that override, you would need to edit the Display Representation Set in the override Display Configuration. I think (but am not certain) that you would need to do that in the Construct file. As before, I am not testing this now, so if changing it in the Construct file does not work, then try it in the View file.

[sharla]

In the View file, with the Display Configuration and view direction set to those giving you the problem, open the Display Manager. Expand the Configurations folder in the left pane, find the Configuration shown in bold type (the current one) and expand that and, finally, select the Display Representation set in bold type (the currently active one, associated with the current view direction). In the right pane, on the Display Representation Control tab, scroll down to the Walls row and clear any check mark in the Graph column. OK your way back out.

That was it! Thank you David! One can get lost in all the settings available!