Results 1 to 2 of 2

Thread: sloped floors with sloped levels and stairs

  1. #1
    Member
    Join Date
    2004-08
    Posts
    27
    Login to Give a bone
    0

    Default sloped floors with sloped levels and stairs

    Hi:

    I am new to this forum. I have this building which has sloped floor but walls are vertical. But how does one tell revit to keep the levels also sloped meaning parallel to floor so that when I get the stairs buil, it takes the level which is sloped along the floor otherwise it just follows the horizontal level line and builds the stair and thus I get huge gap between last riser and the floor because of the slope of loor.

    I hope I am clear enough.

    Thanks

    ss

  2. #2
    All AUGI, all the time robert.manna's Avatar
    Join Date
    2005-05
    Location
    Boston
    Posts
    777
    Login to Give a bone
    0

    Default Re: sloped floors with sloped levels and stairs

    Levels can not slope, they are always "flat". One way or another you're going to have to calculate the exact distance at which your stairs interesect your sloped floor. The eaisest thing would be to create new level and have it intersect the point where you want the stairs to interact with the floor. Your other option is to determine the distance from the nearest level to the point wher ethe stairs intersect, then set an offset in the stair from the level you measured from, thus your stairs will adjust correctly.

    HTH,
    -R

Similar Threads

  1. 2014: Revit LT 2014 for Sloped Floors?
    By DNP in forum Revit - LT Support
    Replies: 2
    Last Post: 2014-01-27, 06:45 PM
  2. Why do sloped floors ignore their level setting?
    By patricks in forum Revit Architecture - General
    Replies: 1
    Last Post: 2011-04-06, 08:46 PM
  3. Mitering Sloped Floors?
    By ricardo.o.maciel in forum Revit Architecture - General
    Replies: 5
    Last Post: 2008-04-29, 07:03 PM
  4. Mirroring on sloped floors
    By Steve Jager in forum Revit Architecture - General
    Replies: 3
    Last Post: 2006-06-28, 08:51 PM
  5. Walls on sloped floors
    By David Haynes in forum Revit Architecture - General
    Replies: 8
    Last Post: 2005-12-06, 08:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •