Hello,
I have a corridor that I am having a problem with. I have a "Daylight General" attached to back of curb. The Cut & fill for Slope 1 are set to 48:1 for a distance of 6'. For the majority of the corridor it behaves correctly. But then all of a sudden it gets sucked closer to the back of curb. I have double checked the targets and I don't seem to have anything that would be causing this. Any Ideas. It is a rather large drawing so I don't think I can upload it. Would a snapshot of the corridor help at all? I just tried to adjust the frequency to a smaller distance but I still get the same areas being closer to the back of curb.
Thanks,
Daryl