Layer Properties status line

[traceyjj]

I seem to have a small problem with the layer properties manager. Normally it has a status line to say how many layers in the drawing etc. On this computer there is no status line. Is there a variable that switches this information off? The other computer that runs 2006 has the status line, but not this one.
I have restarted the computer, but still no status line
Can anyone offer any advice?
Many thanks in advance
T

[rkmcswain]

It looks like the current layer is missing also (in the upper right)?

The only thing I can think of would be to try and run a repair on your .NET framework install.

[traceyjj]

It looks like the current layer is missing also (in the upper right)?

The only thing I can think of would be to try and run a repair on your .NET framework install.

Thanks for your reply. I didnt even notice that part was missing!
Is that solution something the "admins" have to do, or how would I do that?
Thanks again
T

[rkmcswain]

If you have permissions.. follow this.

Add/Remove Programs
Microsoft .NET framework x.0
Change/Remove
Repair
Next

[traceyjj]

If you have permissions.. follow this.

Add/Remove Programs
Microsoft .NET framework x.0
Change/Remove
Repair
Next

Unfortunately I can only get to the change/remove then it asks me to contact the admin Looks like I'll have to contact them and wait (and wait)
Thanks for your help. Much appreciated.
T

[traceyjj]

The update was the key.
Thanks again
T