Hello,
We are experiencing problems with our custom line types. We have LDD & Map 2008 loaded on all computers. All network paths have been checked and updated for linetypes, fonts menus etc. to work on each computer. The line types we are having trouble with are DITCH, and SLOPE. The ditch linetype is showing as a dot, the slope is showing as a continuous line. This was a big problem last week, now it seems to be just a few drawings we are having the line type problem with. These were drawings created in version 2004. We have re-loaded the line types into the drawing, did a regen and worked. However, when you exited the drawing, and went back in, the custom line type would change back to dot and continuous.
Any help will be greatly appreciated. Thank you in advance.
Best Regards,
Peter Haveman