I have a generic model sweep that is placed in the model but i am unable to select it now that it is in the file. Any suggestions?
|
I have a generic model sweep that is placed in the model but i am unable to select it now that it is in the file. Any suggestions?
If you can see it but can't select it, then maybe it is part of a Design Option If yes, make its design option editable to select it.
Andre Carvalho
i have checked and it is not a design option. The only way i have found to select it is to go to the family in the project browser and have it select all instances.
I know this is an old thread but has anyone else had this problem or found a solution? I made a generic family and placed it in the model. Now I cannot select it other than select all instances in model which is not good for me. I need to move them around individually.
the only other things it could be are it is on a workset and you are working in a different workset or it is pinned and the 'select pinned elements' is turned off (yellow pin in bottom right of revit)