Results 1 to 1 of 1

Thread: Pipe Elbow Angle problem

  1. 2008-05-29, 03:11 PM #1
    Avatart
    Avatart is offline
    All AUGI, all the time Avatart's Avatar
    Join Date
    2004-06
    Location
    Upsidedown in dreamtown
    Posts
    928
    Login to Give a bone
    0

    Default Pipe Elbow Angle problem

    I have an issue with joining pipes (of same size, type and elevation) at an angle greater than 90deg, I keep getting the effect as in the image attached. If i try and straighten out the crooked bit, the pipes won't join, giving me the infamous "No auto-route solution was found.".

    Help!
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 2013: MEchanical Settings - Elbow Angle Increment?
    By ccenergy in forum Revit MEP - General
    Replies: 2
    Last Post: 2012-10-18, 11:07 PM
  2. Non-90° Pipe Elbow Appearance
    By Illiniwek in forum Revit MEP - General
    Replies: 2
    Last Post: 2012-04-16, 09:00 PM
  3. Pipe elbow not being created
    By matt__w in forum Revit MEP - General
    Replies: 1
    Last Post: 2010-05-21, 04:04 PM
  4. Pipe Elbow Size
    By phil.pleiss in forum Revit MEP - Families
    Replies: 11
    Last Post: 2010-02-11, 04:13 PM
  5. Pipe Elbow Does not Fit Properly
    By jason.combs in forum Revit MEP - General
    Replies: 2
    Last Post: 2008-08-08, 04:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules