anyone know how to create the eccentric part from content builder at pipe category?
i was tried to created but it came out concentric part.
anyone know the ways to create?#
thanks
sam
|
|
|
anyone know how to create the eccentric part from content builder at pipe category?
i was tried to created but it came out concentric part.
anyone know the ways to create?#
thanks
sam
Check out this post (it is for a duct takeoff, but it might give you a hand...)
http://forums.augi.com/showthread.php?t=71522
-Buzz
Some month ago I made the attached LISP - but I think it is obsolete now: we can use the LOFTs and SWEEPs yet.
(Remove the .txt-extension, load in AutoCAD and start with SQTORND or RNDTORND.)
Regards
Jochen