Dynamic Blocks Requiring Audit

[ross.gallagher]

I have created a dynamic block that contains an attribute definition that can rotate & move and works well if I don't do anything else. As soon as I do something else (even save) then come back to my block I can't do anything until i AUDIT, then I can work away on my block happily again.

Has anybody heard of this problem / know what could be causing it??

I am using Civil 3D 2008. I have the upgrade for 2009, but have not installed it yet. Has this problem been fixed in 2009?

[derek.96018]

Have you tried to RE-insert the block into the drawing ? I have found that sometimes a block needs to be inserted for the changes to work properly....

Also, are you testing the block as you create it ? meaning put in your parameter and acton, then test. put in your next one and test. Sometimes the problem part can be found that way. If it is not a complicated, starting from scratch is best....

Good luck