That is to say the small 'o' that goes at the top right of the number.
Try as I might I cant find it mentioned in 'help'.
Many thanks
RD
|
That is to say the small 'o' that goes at the top right of the number.
Try as I might I cant find it mentioned in 'help'.
Many thanks
RD
Give people a job worth doing, the tools to do it, recognition of a job well done & get out of the way.
Give people a job worth doing, the tools to do it, recognition of a job well done & get out of the way.
Here is a list of %% text tweaks.
%% c = diameter
%% d = degree
%% o = overline
%% p = +/-
%% u = underline
Give people a job worth doing, the tools to do it, recognition of a job well done & get out of the way.
Do you mean plotting area on a layout tab? If so, you can do a page set-up & change your printer settings to accommodate different page sizes.
Give people a job worth doing, the tools to do it, recognition of a job well done & get out of the way.
R.K. McSwain | CAD Panacea |
Er.. Dont think so. When you start a drawing from scratch you enter the width and length, in my case 400 x 500. I now find that is too small. I want to make it 400x 800. It's not that I want to plot it to paper I want the grid lines to extend to 800. Hope this makes sense. Thanks
RD