Results 1 to 2 of 2

Thread: Unable to read CUI

  1. #1
    Member
    Join Date
    2008-05
    Location
    Los Angeles, CA
    Posts
    35
    Login to Give a bone
    0

    Default Unable to read CUI

    This morning I went to open C3D09 and it opened without any of my top menus. However, if I open up regular Autocad is does just fine.

    When I tried to run CUI in C3D09 it gave me the following message "Unable to open file "The support folder path"\civil.cui". When the CUI dialog opens it is empty.

    Does anyone know how to remedy this?

  2. #2
    Active Member
    Join Date
    2005-04
    Location
    Richmond, VA
    Posts
    73
    Login to Give a bone
    0

    Default Re: Unable to read CUI

    Couple things...

    1. Check the path to your main customization file (OPTIONS command).
    2. verify the file hasn't gotten deleted

    Assuming that to be the problem, you can reset the CUI file itself by going to the CUI command, right-clicking, and selecting "Reset CUI File".

    If that doesn't work...
    1. Copy the civil.cui from another machine
    2. run a repair reinstall (not 100% sure, but this should "fix" the problem as well)

    On a side note I have had issues with 09 not loading the civil workspaces properly. I just type WSCURRENT at the command line and type civil 3d complete, press enter, and things seem to work their self out.

Similar Threads

  1. Open Read-Only: The ability to open a worksharing enabled file in a read only mode.
    By revit.wishlist1942 in forum Revit Architecture - Wish List
    Replies: 5
    Last Post: 2012-09-05, 07:02 PM
  2. Unable to edit Aclt.cui as it is read-only
    By kwong in forum AutoCAD CUI Menus
    Replies: 3
    Last Post: 2007-04-24, 03:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •