Originally Posted by
tsigler
Hi All,
I am drawing a section with R-30 batt insulation laid on(in?) the ceiling rafters. As I near the bearing end I'd like the insulation to taper with the rafter pitch. I don't now if this can be done in 2009 or not. I found a 2005 thread on Autodesk where Paul Aubin told the questioner that this function could be found in the prompt. I looked in 2009 but see only Left/Center/Right or Shift options in the prompt. Are we going backwards again and losing functions?
Any help would be greatly appreciated. Thanks
Tom