Hi ALL,
Does anyone know how to draw eccentric reducer in inventor?
Photo is attached.
Thanks in advance.
|
Hi ALL,
Does anyone know how to draw eccentric reducer in inventor?
Photo is attached.
Thanks in advance.
Something like this? I used a series of Lofts and ellipses (about 5 minutes). Refine as necessary.
Last edited by BoKirra; 2008-12-12 at 12:56 AM.
Just substitute the work ellipses with circles. Draw your circles, loft, fillet.
Sorry, Richard.
This kind of shape is not so simple to me.
Actually, the reducer has an offset with a straight side.
The problem is that I can't fillet the edges between extrude & loft if 2 circles are line-up on one side.
But this is what eccentric reducer meant.
Again, your helps are appreciated.