Results 1 to 2 of 2

Thread: schedule...tripping me up

  1. #1
    I could stop if I wanted to
    Join Date
    2006-04
    Posts
    418
    Login to Give a bone
    0

    Default schedule...tripping me up

    this is a bit sloppy of a schedule.....the firm prefers the matrix with an "x" i think so i am trying to add a few (two) more columns under "walls" to each subcategory(front, rear etc.)...on the row with the 5/8" and "dens".....i have been trying to ungroup....then group....and i have gone back to the "fields" in edit schedule and added them but i'm not able to mange where they go.......
    Attached Files Attached Files

  2. #2
    Active Member
    Join Date
    2006-12
    Location
    Maine
    Posts
    57
    Login to Give a bone
    0

    Default Re: schedule...tripping me up

    Unfortunately, the heading groups are static. There is no way to control where new fields go except to ungroup and group again... not the best but it's all there is as far as I know. New fields just come in without any grouping.

Similar Threads

  1. 2013: Revit-ASD round tripping
    By markclarenzze in forum AutoCAD Structural Detailing
    Replies: 2
    Last Post: 2014-06-01, 12:27 PM
  2. Round tripping a DWF file
    By greg.mcdowell in forum Revit Architecture - General
    Replies: 7
    Last Post: 2011-07-02, 12:15 PM
  3. Round-tripping mark-ups
    By dgorsman in forum Design Review - General
    Replies: 3
    Last Post: 2010-04-22, 09:21 PM
  4. Lose hyperlinks when round-tripping dwg-shp-dwg
    By lholt in forum AutoCAD Map 3D - Import/Export
    Replies: 0
    Last Post: 2009-04-23, 04:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •