Panel board reassigning circuts

[troy.crandell635379]

Is it just me or has anyone else had this problem. I circut a panel board and then come back later to remove or change one or more of the circuts, and Revit reassigns all the circuts. Is there a way to keep the circuts in place without having to go back in and move them all back to their original spots?

[ash_man1012]

This drives me nuts too.

You might as well just put a big revision cloud around every panel from the start because you never know if it's just going to recircuit your project whenever it feels like it.

I mostly see it when I have to remove a circuit in the middle and just make it a spare (head explodes here)

[james.klatt]

Has there been any response from Autodesk on this issue? If not then can someone from Autodesk please respond to this thread. I've seen this mentioned a few times and this appears to be a HUGE system flaw.

[mjdanowski]

Please develop a usable panel schedule

[troy.crandell635379]

Please develop a usable panel schedule

Are you saying you don't use the Revit panel schedules?

[mjdanowski]

Are you saying you don't use the Revit panel schedules?

Yes. That is why errors such as this are a royal headache for me.