Resequence Problem?

cwhitaker · 2005-05-18, 11:14 PM

When we try to run the resequence command, ACAD E opens the drawing, saves it and then tries to open the "original" drawing again and generates a read only error. This problem comes and goes so it it just more annoying then anything. Has anyone else ran across this problem?

gdwilner · 2005-06-08, 04:33 PM

I ran in to this same problem with AE 2004, on a vary large 300+ drawing project.
The company I was sub-contracted to had a customized batch plot routine.
My work around was to limit the number of pages to less than 100.
I'm sorry I do not know how the final fix was made.

2005-05-18, 11:14 PM	#1
cwhitaker Member Join Date: 2002-02 Posts: 21	Resequence Problem? When we try to run the resequence command, ACAD E opens the drawing, saves it and then tries to open the "original" drawing again and generates a read only error. This problem comes and goes so it it just more annoying then anything. Has anyone else ran across this problem?

2005-06-08, 04:33 PM	#2
gdwilner Member Join Date: 2004-07 Posts: 2	RE: Resequence Problem? I ran in to this same problem with AE 2004, on a vary large 300+ drawing project. The company I was sub-contracted to had a customized batch plot routine. My work around was to limit the number of pages to less than 100. I'm sorry I do not know how the final fix was made.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Image Display Problem	vferrara	AutoCAD General	4	2007-10-15 01:58 PM
Stringer problem	pfrederico	Revit Architecture - General	11	2005-03-24 03:18 AM
Problem and desperation : Level height problem !!	Richard McCarthy	Revit Architecture - General	7	2004-09-10 05:04 AM
Set all objects back to zero Z elevation	alan.gladwin	AutoCAD General	8	2004-08-31 09:04 PM
Block insertion problem	Cad4men	ACA General	3	2004-06-28 03:26 PM