| Saturday, November 21, 2009 |
|
|||||||||
|
||||||||||
|
Welcome, Guest.
|
||||||
| AutoCAD Electrical - General Ask your AutoCAD Electrical questions here! |
 |
|
|
Thread Tools | Display Modes |
2008-04-23, 03:42 PM
|
#1 |
|
100 Club
Join Date: 2006-01
Location: In this Chair
Posts: 170
  |
Circuit Builder
Is there a way to change the TAG1 value of the motor during insert. I have been able to get the wire numbers to match the motor number. For example I want the motor TAG1 to be M1001 the wires to be 1001T1 1001T2 1001T3 and the dissconect switch to be DS1001. Any ideas?
|
|
|
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two Circuit Junction Boxes | mjdanowski | Revit MEP - Families | 5 | 2008-10-09 06:47 PM |
| How to circuit mechanical equipment | ahtkelly | Revit MEP - General | 4 | 2008-01-29 02:31 PM |
| Tagging Receptacles with JUST the circuit no. | sparkie001 | Revit MEP - General | 3 | 2007-09-06 10:24 PM |
| Circuit Properties | jones129 | AMEP General | 2 | 2007-06-02 05:14 AM |
| Problems with Circuit Loads | jones129 | AMEP General | 1 | 2007-04-03 05:11 AM |
Linear Mode
