| Friday, November 20, 2009 |
|
|||||||||
|
||||||||||
|
Welcome, Guest.
|
||||||
|
|
Thread Tools | Display Modes |
2008-06-09, 01:52 AM
|
#1 |
|
Wish List Administration
Join Date: 2006-03
Posts: 1,034
 |
�Ability to Change View Orientation After Creation
Summary: After A view is created be able to edit view and adjust as needed to get a good presentation
Description: Be able to change the base view orientation after a view has been created. How Used: There are times it would be nice to change or tweek a base view of a part or assembly after the view has been created. Perhaps a base view was created as a "pictoral view" to show balloon callouts, etc. Later it is observed that by rotating the view a couple of degrees, some detail might be seen that was previously missed. Currently, the option is to create an additional view or delete and recreate the original view. Feature Affinity: Drawing Manager Submitted By: Byron Funnell on May 27, 2008 |
|
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3d view saved orientation | john.vogt | Revit Architecture - General | 3 | 2007-08-11 06:27 PM |
| Is there a way to change the orientation of an Attribute in a number of Blocks? | .chad | AutoCAD General | 8 | 2007-02-06 06:31 PM |
| Change orientation of 2X4 ceiling grid? | gordon.price | Revit Architecture - General | 8 | 2006-11-17 05:51 PM |
| Wall, Change Wall's Orientation | Jarod | Revit Architecture - General | 3 | 2004-12-13 05:57 PM |
| How to change dim orientation? | Priit.L | AutoCAD General | 4 | 2004-11-13 12:44 AM |
Linear Mode
