BillyGrey
2004-10-27, 09:48 PM
Hey Factory,
I found a glitch when I was aligning a cabinet elevation, it duplicated a cabinet at the alignment height instead of just "moving" it, and left the original at the initial height.
This happened twice in a few minutes.
I was working in a section cut view.
The file was from 6.1. The cab is one of the stock glass front uppers.
If you would like more info, or the file, let me know.
(I did a "save-as" to preserve the file at the moment of bugginess)
Bill
I found a glitch when I was aligning a cabinet elevation, it duplicated a cabinet at the alignment height instead of just "moving" it, and left the original at the initial height.
This happened twice in a few minutes.
I was working in a section cut view.
The file was from 6.1. The cab is one of the stock glass front uppers.
If you would like more info, or the file, let me know.
(I did a "save-as" to preserve the file at the moment of bugginess)
Bill