ntopliffe
2009-05-05, 06:48 PM
Could anyone help me understand how to modify the attached duct part to allow for different radius bends?
http://i13.photobucket.com/albums/a264/ntopliffe/Proffesional/RectangularDuctWye-Curved-Transitio.jpg
I am also looking for this usability feature for the following duct part:
http://i13.photobucket.com/albums/a264/ntopliffe/Proffesional/RectangularDuctWye-smoothradius.jpg
I would rather understand how it is done than have someone do it for me.
Thanks in advance,
Neil
http://i13.photobucket.com/albums/a264/ntopliffe/Proffesional/RectangularDuctWye-Curved-Transitio.jpg
I am also looking for this usability feature for the following duct part:
http://i13.photobucket.com/albums/a264/ntopliffe/Proffesional/RectangularDuctWye-smoothradius.jpg
I would rather understand how it is done than have someone do it for me.
Thanks in advance,
Neil