View Full Version : Revit 2009 - Opening issue
mthurnauer
2009-05-27, 08:12 PM
I am getting a strange behavior where the opening that is being created in a wall is actually shifted from the opening element. what would cause this?
jeffh
2009-05-27, 09:20 PM
I would suspet coordinate really far from the origin. Is there a DWG really far form the origin in this project, or is the project position really far from the Revit origin?
mthurnauer
2009-05-27, 11:33 PM
There are some autocad plans that may have a point way off, but the model was not built far from the revit origin as far as I know. I forget, how do I find the revit origin?
jeffh
2009-05-28, 01:17 PM
I forget, how do I find the revit origin?
In 2010 there are sub-categories under "site" of Survey Point and Project Base Point. These can help you know if you are working far from the revit origin.
In 2009 it is a little more challenging. You have to use the "report shared coordinates" tool or "specify coordinates at a point" this can help you figure out where the Revit origin is in relation to your model.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.