mmiles
2009-06-30, 08:33 PM
Hi all,
A while ago I got advice to create a phase prior to my existing phase in which to place models of all the wall types in my project so that I could use a plan view set to the "wall legends" phase in order to create my wall legend. At the time it made sense, so I set that up. I barely remember how I did all the notations etc....
Now, I have a contractor asking me a question about a wall type that did not make it onto the legend....and I cannot figure out how to add it into the legend view. Whenever I try to copy a wall in the legend, or simply to place a new wall, nothing appears (except a warning stating it is not visible). Even when I make a copy, and select the properties of that copy to change the phase settings nothing appears. It is there, but I cannot see it, and therefore cannot tag and notate it.
Any thoughts on what I am doing wrong?
NEVERMIND: ACTIVE WORKSET WAS TURNED OFF.....UGH:Oops:
A while ago I got advice to create a phase prior to my existing phase in which to place models of all the wall types in my project so that I could use a plan view set to the "wall legends" phase in order to create my wall legend. At the time it made sense, so I set that up. I barely remember how I did all the notations etc....
Now, I have a contractor asking me a question about a wall type that did not make it onto the legend....and I cannot figure out how to add it into the legend view. Whenever I try to copy a wall in the legend, or simply to place a new wall, nothing appears (except a warning stating it is not visible). Even when I make a copy, and select the properties of that copy to change the phase settings nothing appears. It is there, but I cannot see it, and therefore cannot tag and notate it.
Any thoughts on what I am doing wrong?
NEVERMIND: ACTIVE WORKSET WAS TURNED OFF.....UGH:Oops: