Graphic Overrides not working

[kent.220888]

I was working on a project on Revit 2009...switched to 2010...now the graphic overrides that I had set up on interior elevations are gone and i cant reset them for some wierd reason. anyone hear of this?


Im looking to eliminate the cut hatch for the new phase, since its not needed in the interior elevations. any help would be greatly appreciated. Thank you.

attached is a image of a interior elevation. i cant seem to get rid of the grey fill

[iankids]

Hi Kent,

Have a look at the detail level, it might be set to coarse, if so, change it to fine detail & hopefully all is well.

Ian

[Andre Carvalho]

And if it is set to medium or fine, have a look at your visibility/graphics overrides and check if there are overrides for the detail level for the elements that are being cut. In another words, your view may be set to fine, but some elements may have their detail level overridden to be coarse.

Andre Carvalho

[kent.220888]

tried both of those, looked at the detail level overrides, they are all "by view", i dunno whats wrong...ugh. damn 2010.