tbozek
2009-07-15, 08:15 PM
Does anyone know a way to show the terminal jumpers in the schematic. They can be shown on the terminal strip editor and even on the BOM on the panel drawing. I don't want to drawing in wire jumpers, Because they show up in the Point to Point Wiring list.
Currently it shows all separate terminals with no drawn in commonality association shown on the schematic
Commonly I use bussed "jumpered" terminal blocks as Neutrals and Grounds or Common, 24v Source power.
If any one knows a way it would be a huge help.
Currently it shows all separate terminals with no drawn in commonality association shown on the schematic
Commonly I use bussed "jumpered" terminal blocks as Neutrals and Grounds or Common, 24v Source power.
If any one knows a way it would be a huge help.