Roof accessories

[joakim.225708]

Hi,

I have tried to do "roof ends" (I do not know the English word) without success in Revit Architecture 2009.

Here is a link to what I mean: http://www.gardochtorp.se/images/community/blog/4673.jpg

Is there anyone who can help me to do that?

/Thanks

[iankids]

Hi joakim.225708,

Welcome aboard.

Are you looking for the simple gable end overhang or more the detail of the exposed rafters etc?

Ian

[joakim.225708]

Only a simple gable end overhang.

/Joakim

[jsteinhauer]

Only a simple gable end overhang.

/Joakim

When you start drawing the roof outline. Select the line that represents the gable end, and uncheck 'Defines Slope". This will tell Revit that face goes straight up and down.

Best of luck to you and your Revit adventures.

Jeff S.

[joakim.225708]

Thank you for your answer but I think we missunderstod each outer. There is the two white boards in the picture I have problem with.

Sorry for my english...

/Joakim

[barrie.sharp]

Fascias are made with a roof sweep. Setup up the profile you need and your set. Hope that's enough to get you on the right track. Check the help file under the roof section for the full procedure.

[joakim.225708]

Thank you! Now it´s working :)

[jsteinhauer]

Good job Barrie,

I'm adding to your reputation for that one.

Jeff S.