Gap Between Grid Head and Grid Line

[brent.130528]

I am using the hexagon grid head, which I have made smaller per our office standard. Doing this creates a small gap between the head and the line. How do I extend the line to touch the head?

[benmay]

Just check the grid head family and possibly turn on the reference planes you need to make sure it is in the correct positon in the family and ref planes are often turned off on annotation familes

[brent.130528]

I checked the position relative to the reference planes, and it is exactly centered over the intersection of the two planes. Any other thoughts?

[brent.130528]

I found it! There are two lines of invisible line type that I reduced in length, which fixed the problem.