phizzman
2009-08-19, 06:50 PM
Hello Everyone!
Revit Struct 2010
I am trying to create a (curved) ramp that has sloped bottom (and a thickened edge on one side). I thought I could just create the ramp the full thickness that I need and cut the shape out with a void extrusion.
This is preferable to creating additional material with a sweep. I am using the swept blend tool so I can select the edge I want for the profile.
However, after I create the in-place void, Revit will not let me select the ramp I want to cut. Do I need to set the category of the void to a specific type to cut the ramp? or is not possible?
Thanks for any help
Dave P.
Revit Struct 2010
I am trying to create a (curved) ramp that has sloped bottom (and a thickened edge on one side). I thought I could just create the ramp the full thickness that I need and cut the shape out with a void extrusion.
This is preferable to creating additional material with a sweep. I am using the swept blend tool so I can select the edge I want for the profile.
However, after I create the in-place void, Revit will not let me select the ramp I want to cut. Do I need to set the category of the void to a specific type to cut the ramp? or is not possible?
Thanks for any help
Dave P.