Roof Pattern Reversed?

[Jason]

Dear Reviteers,

The pattern on the main roof displayed correctly. However when I tried to draw a shed roof using the extrusion method, the pattern displayed in reverse. Is there a setting for this? Please see attached file.

Thank you,

[adegnan]

You should be able to hover over the pattern, "tab" to select a line in the pattern, then mirror or rotate the pattern as necessary. HTH

[aggockel50321]

If the surface pattern of the shingles is a model pattern (most likely is), you can hover over it with the cursor, tab until you select it, pick rotate, and enter 180 as the angle. The pattern will rotate 180°.

[adegnan]

Ha! FOr once I beat someone to it... barely! :)