Wall Sweep visibility in plan

[GS Fulton]

Is there a way to turn off wall sweep visibility in plan views? Can't seem to figure it out. TIA

George F

[Steve_Stafford]

Visibility/graphics > walls > walls sweeps - cornice

[GS Fulton]

Thanks Steve but that was the first place I looked. Wall sweeps does not show up under walls in the visibility window. If I highlight it in plan, it identifies it as a wall sweep. Cannot find it under visibility settings. I'm sure (I hope) it's right in front of my face and I'm missing it.

George F

[christopher.zoog51272]

Thanks Steve but that was the first place I looked. Wall sweeps does not show up under walls in the visibility window. If I highlight it in plan, it identifies it as a wall sweep. Cannot find it under visibility settings. I'm sure (I hope) it's right in front of my face and I'm missing it.

George F

George,

I think you can only control the visability of a sweep when it is specifically assigned to a subcategory of walls for example "Wall Sweeps - Trim" You have to edit the sweep and assign it to a subcatergory that you can turn off. See the pics.

HTH,
Z




http://www.zoogdesign.com/albums/revit/vv.sized.gif
http://www.zoogdesign.com/albums/revit/os.sized.gif
http://www.zoogdesign.com/albums/revit/ws.gif

[GS Fulton]

Thanks a lot Chris. That did it. I was pretty sure there was a way but pulled some hair finding it. Can't believe I haven't learned that in almost 2 years with revit. Maybe that should go into the tips & tricks?
Thanks again.

George F