Room is not in a properly enclosed region

[GirlForRevit]

I have two slopeds walls. Thay are Room Bounding, but when I try to place room, i cant.....



Why??????

[Andre Carvalho]

Have you checked this thread?

http://forums.augi.com/showthread.php?t=85192

Mainly the part about height of walls...

Andre Carvalho

[ldrago]

Can you post an image of your room?
LD

[GirlForRevit]

It is about editing wall profile, but i dont know why this happend

[tamas]

If your wall has an elevation profile of an upside down trapezoid (top is wider than bottom), you may have hit a rare bug that was just recently discovered.

You can always use room separation lines where you think you miss a room boundary to fix your rooms.

Tamas

[GirlForRevit]

If your wall has an elevation profile of an upside down trapezoid (top is wider than bottom), you may have hit a rare bug that was just recently discovered.

You can always use room separation lines where you think you miss a room boundary to fix your rooms.

Tamas

Lucky me....

[azmz3]

If you have any openings near the bottom of the wall at the floor or at the top of the walls near the ceiling or roof, you would get this message as well. I learned this on the project that I was woking on recently.

[jsteinhauer]

If nothing else, you can add a room separation line and lock it to the wall. That doesn't solve the issue as to why this is happening though.

Hope this helps,

Jeff S.

[GirlForRevit]

A wall and a room separation line overlap.
Than I must say that those walls is not room bounding.....
Me and my problems....

[jsteinhauer]

A wall and a room separation line overlap.
Than I must say that those walls is not room bounding.....
Me and my problems....

Open a new project & copy paste the room/s in question to that and post to Augi. Someone should be able to figure it out for ya. :)

Jeff S.

[GirlForRevit]

You think so. Who will be so kind????
I will do that tomorrow, firs thing in the morning....