Wall Join Structure Changes?

[barrie.sharp]

Please look at the attached pic. The highlighted wall looks like it's made of brick and concrete. You can see from the wall properties that this is not the case! It was fine until I changed the wall join on the corner and the wall seemed to change structure. Any ideas?

[d.stairmand]

Barrie
It could be the Wall Function Categories.
Finish 1 should be External Linings
Finish 2 should be internal Linings

This may help?

[barrie.sharp]

LOL :Oops:. Yes, just noticed the external skin was set to structure. It's behaving now! Too close to the subject to spot the blinking obvious.

Thanks