Concrete beam-to-wall join

[jj mac]

Please see attached!

I am trying to get this concrete beam to trim in with the wall, but it wants to stick out as shown...

Is it possible to trim this with the wall somehow?

I know we can use the linework tool in plan/section to fake it, but we have many of these conditions to deal with...

Thanks

[mrice.47661]

I can think of 2 approaches ...

One would be that you could try and use the join geometry tool if you haven't done so already. This may give you the "clean up" you're looking for.

If you've given that a shot already, you might instead create an in-place void family to trim up the end of the beam and have it hit the wall geometry more cleanly.

Hopefully that helps.