Top of Conduit Label

[Quic_Kad]

Does anyone know how to change the display settings for the Top of Conduit tool? when I use this tool, click the pipe the note comes out in inches I think. I need foot/inches 9'-0" for example. Displays TOC:7,636.6+4/2 ???? what is this? Thanks for the help

[david_peterson]

I'm not sure cause I don't play with MEP much, but I'm guessing that it found the actual elevation of the top. Change the tolerance on the tag to be in 1/4". You could also do this in the units and ramp down the rounding from 1/256 to say 1/4. Just a thought. Again, I don't know what that tag is looking at.