Stacked Walls & Room Boundaries

[hgrigel]

I am having issues with a model that I did not create, but have been recruited to fix a problem. The model has an entry area off of which are two hallways. The two hallways coming off of the entry are connected to the entry via a wall opening that was placed within a stacked wall. When I go to place a room tag, the entry reads as one room and each hallway reads as a separate room. I cannot change the stacked wall the openings are placed within to non-bounding. Any suggestions for getting the entry and the two hallways to read as one room?

[SUB]

1. delete wall opening and edit profile to recreate opening
2. select stack wall, right click, break up the stacked wall and set both to not bounding

[Scott Womack]

1. delete wall opening and edit profile to recreate opening
2. select stack wall, right click, break up the stacked wall and set both to not bounding

You don't have to break-up the stacked wall. It is easier in a Section view, but by Tabbing over the stacked wall, you can actually select the individual walls within the stacked wall, and change it there to non-bounding.