Title Block Info

[lzcncpcn]

I made a title block family and the requisite shared parameters for the engineer and architect names, license numbers, and similar information which we need to show on our permit sheets in our country. But when I insert the sheets, I found that I have to enter the information for EACH sheet.

Is there any way to make parameters that will behave in pretty much the way the Project Information does? You enter them once and they show up everywhere they are referenced to in the other drawing sheets?

Any insights would be much appreciated. Thank you!

[Steve_Stafford]

You need to associate the parameters with the Category Project Information, not Drawing Sheets to get what you are after.

[patricks]

I was hoping to do something similar with a shared Yes/No parameter called Preliminary Issue, that would turn on or off a preliminary issue note on sheets, and have it available through the Project Information dialog in project files. However I can't seem to associate it with with the note in the title block family.