studio3p
2003-09-11, 06:26 PM
I am having difficulty finding how I adjust the material map for a material so that it aligns with its corresponding surface pattern. Within the material editor I see where I can adjust the tiling and size of a given map, but I don't see anything for adjusting alignment or origin points.
In this particular case I have created a ceiling using the ACT 24x24 that is included with the default project templates. After placing the ceiling I adjusted the surface pattern to achieve the desired alignments. When I render the model though the map pattern clearly does not align with the surface pattern. You can see the mismatch between the two attached files.
Any suggestions or obvious answers that I'm missing?
Thank you -
In this particular case I have created a ceiling using the ACT 24x24 that is included with the default project templates. After placing the ceiling I adjusted the surface pattern to achieve the desired alignments. When I render the model though the map pattern clearly does not align with the surface pattern. You can see the mismatch between the two attached files.
Any suggestions or obvious answers that I'm missing?
Thank you -