florin_balcu
2004-11-16, 12:01 PM
Hi,
I have a cell in cut (~250000 cubic m) which needs to be filled in a way that three sides (E, W, S) should have 6:1 slopes and the other one (N) 3:1 and also to keep 4m as minimum distance from the northern side (which allows later to re-fill the cell).
Then I need to calculate the new volume.
I have already built a surface from this cell.
Is there a way to accomplish this?
Thank you,
Regards,
Florin Balcu
Perth, Western Australia
I have a cell in cut (~250000 cubic m) which needs to be filled in a way that three sides (E, W, S) should have 6:1 slopes and the other one (N) 3:1 and also to keep 4m as minimum distance from the northern side (which allows later to re-fill the cell).
Then I need to calculate the new volume.
I have already built a surface from this cell.
Is there a way to accomplish this?
Thank you,
Regards,
Florin Balcu
Perth, Western Australia