3dway
2009-10-21, 07:29 PM
Is it possible to get the top rails to connect with the corner posts?
We have a simple pipe rail stair raiilng with 40mm top rail, 40mm end posts, and 40mm corner posts all round.
When I set this up in Revit, I can't seem to get the top rail to fillet (in acad terms) with the end post. Also, at the landing, I expect the top rail to have a vertical segment to make it up to the handrail height for the next flight. Here the corner post extends up to the higher handrail, and the horizontal top rail at the landing doesn't create a vertical segment.
Both settings are at "create horizontal and vertical segments".
Any help?
We have a simple pipe rail stair raiilng with 40mm top rail, 40mm end posts, and 40mm corner posts all round.
When I set this up in Revit, I can't seem to get the top rail to fillet (in acad terms) with the end post. Also, at the landing, I expect the top rail to have a vertical segment to make it up to the handrail height for the next flight. Here the corner post extends up to the higher handrail, and the horizontal top rail at the landing doesn't create a vertical segment.
Both settings are at "create horizontal and vertical segments".
Any help?