Permanent Hide...

[RodneyLester]

Is it possible to permanently hide objects in a view so they are not seen or plotted? Not the temporary hide that gets reset when you close/open the project file.

Also is there a way to globally change which curtain wall mullions run through? By default it always runs the vertical through... It is quite laborious to have have to change each one individually on a building covered with curtain wall.

[aaronrumple]

A. Worksets. (..see other posts)
B. Not that I've found.

[beegee]

Is it possible to permanently hide objects in a view so they are not seen or plotted? Not the temporary hide that gets reset when you close/open the project file.
.Sure, you can turn off entire categories / subcategories permanently in a view using the visibility graphic over-ride dialogue.