Pads and site slivers

[domglam]

I guess this has been discussed before.....

I have found that when i create connected pads with a sloping element between that i often end up with small slivers of site protruding up between the joins. It appears that the height of these slivers is controlled by the 'height offset from level.

I have set up all of the pads to be associated with level PLAN GF, and used a slope arrow associated with offsets from the same level.

weird?...or am i missing something simple.

[jeffh]

You can try reversing the slope arrow. Sometimes this will fix the problem.

[domglam]

I guess it is not so much of a problem, as a discovery that the sliver height is controlled by the height offset from level....it was something that was bugging me for a while.