Ribbon Tap out of order

[wadeshuey]

Hello everyone,

I am stumped... my ribbon has gone haywire and I don't know how to fix it. My tabs fell out of order instead of the order being "Home" "Annotate" Massing and site" it goes "Insert" "modify" "Manage" "Add in's" Then "Home". I have tried pulling them over but I cant figure this out, any ideas

Thanks

[ws]

You could try the reset suggested here maybe:
http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=13126319&linkID=9243099

[wadeshuey]

THANKS I WILL GIVE IT A SHOT!

[Revit MEP DR]

I too have run into this, I'll check out the link above, but wanted to post a picture for people to see exactly what is haywire.

Thanks

[timothy.bungert]

I think its been mentioned in other threads, but you can reorder all of your tabs by holding down the CTRL key and dragging the tab where you want it to be. Kind of nice because the latest service pack placed the new STRUCTURAL tab clear over on the right hand side. I moved it back next to the HOME tab and all of my other building modeling tools.