mr6jam
2009-12-04, 09:02 PM
Is there a way to get a custom Revit View Title to be automated similar to the "Revit out of the box" one? If you look at the attached PDF, you can see the View Title I would like to have. It should have a grip the way the original one does so you can stretch the Title. Is this possible? I opened the family and attampted to get it to work, but no luck.
I attached the Revit Family called "GSva View Sub-Title.rfa", but that is as far as I could take it.
I can get the one line to stretch, but not the line above and below (as can be seen in the PDF) to get it boxed.
Any ideas?
I attached the Revit Family called "GSva View Sub-Title.rfa", but that is as far as I could take it.
I can get the one line to stretch, but not the line above and below (as can be seen in the PDF) to get it boxed.
Any ideas?