More Filled Region Q's

[designer56644]

When I push "Send to Back" during a filled region edit,
does that mean to the back of the visibility range, to the back of all levels, or to the level I am currently on? (Whew)

I have a site plan I am developing, and any filled region I am inserting
"run over" my Revit generated property lines. I need to maintain visibility on my PL's, but can't "send back" my regions far enough.

Derrrr, I hope that makes sense ;p

Thanks

[sbrown]

The easiest thing is to just draw a detail line of your property line over top of your "real" prop. line.

The other option is discussed in detail on the tips and tricks forum under the heading of transparent filled regions or something like that.

[designer56644]

Thanks Scott,

I was hoping something magical had happened
when I was'nt looking and I would'nt have to resort to that.
My dillema seems to go a little further than just the PL issue, but that seemed a good enough example.

I'm sure Santa is listening, so I hope Region Fill controls and enhancements are near the top of our
xmas present list : ) Lots of room for improvement needed there.

Thank you sir,
BC