patricks
2009-12-07, 04:15 PM
I'm getting a weird warning about a small piece of roof I placed on the end of a gable. The piece of roof itself is only about 8" wide, and the roof assembly is around 5" thick.
I assume it as to do with the slopes I set to the roof. The long side (along the gable) is set to 1/12, and the 2 short sides are set to 6/12. When I finish the roof, it says "Room computations only succeeded without considering the following elements" and it has that roof highlighted.
I assume it has to do with the roof only barely having actual 6/12 surfaces before changing to the 1/12 surface. If I change all 3 slope-defining sides to 1/12, the warning goes away. Even if I click on the roof now with the 6/12 sides, it does not give me a Review Warnings button, so it must not be that big of a deal.
I assume it as to do with the slopes I set to the roof. The long side (along the gable) is set to 1/12, and the 2 short sides are set to 6/12. When I finish the roof, it says "Room computations only succeeded without considering the following elements" and it has that roof highlighted.
I assume it has to do with the roof only barely having actual 6/12 surfaces before changing to the 1/12 surface. If I change all 3 slope-defining sides to 1/12, the warning goes away. Even if I click on the roof now with the 6/12 sides, it does not give me a Review Warnings button, so it must not be that big of a deal.