RAC 2010 Door

[azmz3]

Ok, I am spending to much time on this, so I am going to pist it to get some other eyes to look at it. I have a simple door frame family, with a depth parameter for the frame. when I change the parameter, it does not stay centered inside the wall even though i have my reference planes centered, and my equal dimension placed. Please take a look, and give your suggestions. Thanks.

[cporter.207875]

Here you go. It is all in the order of operations. Plus you had some redundant ref planes that were loose.

[azmz3]

Ah, thanks for the help. It has been a little bit since making a new family, and I just wasnt seeing my error in there.

[Mike Sealander]

A handy trick I picked up recently is to change the wall in the family to 1'-0" thickness. For some reason the 6" thickness can lead to a lot of family creation errors.