Design of a bath

[morgado_ruben]

Can someone help me create this bath in 3D?

I could do it with a sweep, around a rectangle void of the base of the bath and then create one more solid to close up the bath.

Any other ideas?

Thanks

[sbrown]

Get the cad file from the company and just import it into a plumbing fixture family. Then turn it off in plan an place symbol lines in your family to represent it.

[patricks]

Get the cad file from the company and just import it into a plumbing fixture family. Then turn it off in plan an place symbol lines in your family to represent it.

If that doesn't work, then I would just do a blend solid and a blend void, and probably not worry about getting the bottom edges of the inside to curve. I say do a blend, since the bath tub flares out more on the ends than on the sides as you go higher from the bottom.

If you wanted the curved bottom, do a sweep and pick the bottom edges from where your void blend cut the solid blend.

[patricks]

Something like this? I did it in Imperial units, but I converted the dimensions from that cut sheet, so they should be the correct dimensions if you bring it into a metric project.

[morgado_ruben]

Thank you all for your ideas but I learned to use the sweep...so I will use it to give more detail to the model.

[morgado_ruben]

Thanks for the model you did...it is exactly the bath but I had dificulty understanding how you did the blend solid.