2010 Interface Issue

[saeborne]

Hi All,

So, I'm in the middle of the following command:

3D Window
Edit an In-place Family (wall category)
Edit Extrusion Sketch

I continue to get these extra rows under my ribbon. See the attached image... clouded in red for clarity sake. The number of rows vary, every time I click, pan, zoom, rotate, select. It's killing me!!!

Is this a known issue? Is there a fix for it?

Thanks in advance.

[twiceroadsfool]

Known issue, very very annoying. Comes and go's without consistancy.

Some people have reported the issue is better depending on where the options bar is docked (top or bottom of screen), and some have noted its better or worse depending on where the QAT is docked (below or above ribbon). Some have also seen differences depending on whether the Browser is on-screen or detached. Ive seen it go haywire in all configurations.

Its consistantly inconsistant.