Rodan2000
2010-01-13, 08:48 PM
I can't seem to get the array for the laminations down correctly in the Structural Framing Glulam family.
I wanted them just to be shown as symbolic lines only (cut and projection) for details/elevations.
I began with drawing a symbolic line at the top of the beam in the left elevation view, did an array with the last being aligned to the bottom of the beam.
If I flex the family, no matter what I do, I get constraints not satisfied. Here's the key points:
1. Align and lock first line to top of beam (reference line).
2. Array line with last line aligned and locked to bottom of beam (reference line).
3. Assign 'Laminations' parameter to the array.
4. Align and lock first line to left and right side of beams (reference lines).
If I get any interest in this, I'll remake the family and attach it... I'd appreciate any help!
I wanted them just to be shown as symbolic lines only (cut and projection) for details/elevations.
I began with drawing a symbolic line at the top of the beam in the left elevation view, did an array with the last being aligned to the bottom of the beam.
If I flex the family, no matter what I do, I get constraints not satisfied. Here's the key points:
1. Align and lock first line to top of beam (reference line).
2. Array line with last line aligned and locked to bottom of beam (reference line).
3. Assign 'Laminations' parameter to the array.
4. Align and lock first line to left and right side of beams (reference lines).
If I get any interest in this, I'll remake the family and attach it... I'd appreciate any help!