j_starko
2010-02-11, 05:00 PM
Hey,
we've got a small and new drawing being set up. and we're having view range problems.
The floor plan is set up, and we're trying to have the view depth go below the floor, showing the piles and footings. when the view range dialogue box is opened, the selection box for bottom and cut plane is greyed out. and when we try to make the view depth be something like -2000, it's saying that the view depth is above the top view range. We've even added a new level below the main floor to see if that would change things.
It's a small building and there isn't a lot drawn so we're going to start from scratch again, and hoping not to have any issues. but has anyone had any experience with view range manipulation like this ?
we've got a small and new drawing being set up. and we're having view range problems.
The floor plan is set up, and we're trying to have the view depth go below the floor, showing the piles and footings. when the view range dialogue box is opened, the selection box for bottom and cut plane is greyed out. and when we try to make the view depth be something like -2000, it's saying that the view depth is above the top view range. We've even added a new level below the main floor to see if that would change things.
It's a small building and there isn't a lot drawn so we're going to start from scratch again, and hoping not to have any issues. but has anyone had any experience with view range manipulation like this ?