Layer Combo Control in QAT question:

[mhutchinson.121719]

I've placed the Layer Combo Control in the Quick Access Toolbar...
I know when this is expanded the width takes on the longest layer name.
However, is there a way to make it longer when the control is at rest?
I see the Minimum and Maximum width is set to 'NaN'... what does this mean and how can I change it?

[buzz]

I didn't think you could put controls in the QAT, only commands...

-Buzz

[RobertB]

I've placed the Layer Combo Control in the Quick Access Toolbar...
I know when this is expanded the width takes on the longest layer name.
However, is there a way to make it longer when the control is at rest?
I see the Minimum and Maximum width is set to 'NaN'... what does this mean and how can I change it?I've been pondering that myself. The guts of the XML offer no clues. I guess I'm just going to have to experiment when I get the time.

[RobertB]

I didn't think you could put controls in the QAT, only commands...Nope, you can at least put the Layer Combo Control on the QAT. You need to locate the control on the Panel rather than the Cmmands pane and drag-and-drop it from there on to the QAT node.

[buzz]

Nope, you can at least put the Layer Combo Control on the QAT. You need to locate the control on the Panel rather than the Cmmands pane and drag-and-drop it from there on to the QAT node.

Ahh I see, I closed that ribbon down with reckless abandon on day one, so I was trying to drag-drop it from the CUI (which doesn't work).

-Buzz

[le_m4lin]

from what i discovered so far...

the minimum value is 50 and the max is 1000 (pixels?) - default is NaN

i'm running a 1920x1080 screen resolution

the max width will actually stretch the pull down menu to 1000, but the text stops at 400-ish - so there's no point in stretching it more that 450 (this is unfortunate)

i'm not sure what the minimum value does... it didn't change anything for me so I left it to its default value.

can someone figure out if there's a way to display the layer name past 400 pixels?